Powernation

Watch Powernation live with Fubo for $0 Today

PowerNation is your destination for classic Muscle Cars, horsepower-fueled engine builds, trucks, 4x4’s, and much more!

302 vs 305 Pt 3 High Compression Showdown

Engine Power

S12, EP9 "302 vs 305 Pt 3 High Compression Showdown"

The battle between the Classic 302 SBF vs. 305 SBC continues; going head-to-head, Ford vs Chevy; keeping it simple with only one change, compression!; increasing the compression on both engines and getting them as close as possible.

Engine Power

S6 "Big Foot Engine Build, Part 1"

Engine Power gets the honor of rebuilding the 640-inch blown nitrous injected V8 from the original Bigfoot monster truck.

Engine Power

S6 "Big Foot Engine Build Part 2"

The team visits Kaase Racing to machine the 640 inch Ford big block from the first monster truck, Bigfoot 1.

Engine Power

S6 "Big Foot Engine Build, Part 3"

Mike and Pat assemble and dyno tune a massive 640-cubic-inch, tri-power 429 Ford with an 871 blower and nitrous.

Truck Tech

S2, EP9 "BigFoot Lives"

Original BigFoot monster truck comes alive after 23 years with a new transmission and blown engine.

Engine Power

S13, EP1 "Sleeper 534 Big Block Chevy"

We work on building a big torque, big horsepower, pump gas 534 cubic inches Big Block Chevy disguised as an old school stock engine; this build uses a host of high-tech aftermarket pieces, but it's designed to swap into anything that a big block will fit into; we go from a table full of parts to a full-blown dyno session to see what it cranks out.

Engine Power

S12, EP13 "427CI LSX, Part 1"

We build a 427ci pump-gas LSx for a Music City Trucks C10, aiming for hot rod power.

Engine Power

S12, EP14 "427ci LSx Part 2"

The 427-ci LSx engine for Music City Trucks' C10 is being completed with EFI and dyno-tuning.

Dirt & Trails

S1, EP10 "Project Rapid Runner Introduction -- SEMA Build Part 1"

Chris and Eric must build the kayak vehicle, a Nissan Frontier Pro 4X, in one month.

Dirt & Trails

S1, EP11 "Project Rapid Runner is Complete - SEMA Build Part 2"

Under a tight deadline for SEMA, Chris and Eric are scrambling to finish their Nissan Frontier.

Engine Power

S10, EP5 "Boosting a Stock 460ci Big Block Ford"

We turbocharge a bone stock Big Block Ford on the cheap.

Engine Power

S1, EP9 "Iron Animal Part 1: Building a 408 Stroker"

Building a modern Chevy stroker starting with an LQ4 iron truck block that can survive turbo boost.

Engine Power

S1, EP10 "Iron Animal Part 2: Flow Bench Testing Heads"

Cylinder heads are flowed, installed and topped off before being dyno tuned on pump gas.

Engine Power

S1, EP19 "Iron Animal 408: Wicked Turbo Power"

Turbo-charging an iron block LS stroker to make 1000 horsepower with an 88mm turbo and air-to-air intercooler.

Carcass

S3, EP5 "Abandoned Chevy Silverado Project Part 1: Rust and Dent Repair Tech"

Tips on how to repair rusty trouble spots and remove dents; a walk through of getting a project primed.

Carcass

S3, EP9 "Abandoned Chevy Silverado Project Part 2: Junkyard Motor Refresh"

The crew source a drivetrain for a 1996 Chevy Silverado.

Popular channels included with Fubo